Here is the Hardware for the Software.

This runs through the Arduino. At one end it communicates with the Flex Sensors and on the other it decodes the info from cSound.

This is a table of the Instruments that I used and gives info about them (ie. amp)

This is the set-up for the instruments.

I had 5 flex sensors. The first one was the beat which only faded in and out with the bend of the sensor.

The second and fourth instruments were the strings. The second one was a fader for the strings and the fourth one had a distorter on it, which would turn on and off.

The third and fifth instruments are the piano. The third is the fader and the fifth is a vibrato effect that would turn on and off the effect when bending the sensor.

This is the serial to read format.

BACK