i decided to press on, and fit the LED rails in place. first i measured and drilled holes into the board conforming to the holes pre-drilled in the seam binder
a couple nuts and bolts later,
i had a good-lookin' board
no mind about the level just yet... just wanted to get the speedometer working with the LEDs. not too difficult, right? so i contacted the master. uh oh, little problem
and so i have reached quite a bump in the road. as of yet, this project is unfinished. however, hopefully with a little sage wisdom from sandy, jerry, etc. on one-chip computers, the skate board will yet be realized.
until then...
